Xantech XT-DL-IRK Installation Manual page 4

REMOTE ROOM APPLICATION
One application is to locate the IR receiver in a remote room. This will give the
DL Series
end-user the ability to control audio/video equipment from a location where the
IR Receiver
remote control no longer has the ability of direct line-of-sight.
Red
The IR receiver will need the 3.5mm stereo type mini plug removed to extend the
Talkback LED
wire run to the connecting block. A 4-terminal block is included to connect the IR
receiver to the connecting block with a 3-conductor inter-room cable in between.
Red (or white)
Stripe
IR OUT
+12V
7' Ribbon Cable GND
The 3-conductor inter-room cable (24 gauge up to 200', 22 gauge up to 600', 20
gauge up to 2000', 18 gauge up to 5000'), is run to the main room.
3-Terminal Block (not included)
Input connections must be made as illustrated. To extend the emitter wires to
REMOTE ROOM
Remote Room
DL Series
IR Receiver
a more distant location, you may splice in 2-conductor wire, in the wire gauges
mentioned before, as needed.
While it is possible to make wired connections without the connecting block, it
is not recommended. The connecting block reduces installation time, helps to
eliminate errors, allows easy troubleshooting and permits easy system upgrades
later, if needed.
IR Photodiode
Hand Hel d
Remote
3-Conductor
Inter-room Cable
(unshielded OK)
PS12-0.5
3-Conductor
+12 VDC
Inter-room Cable
(Unshielded OK) GND
STATUS
IR IN
781ERGPS
To 120 V AC
(unswitched)
789-44
Connecting Block
+12 VDC
GND
STATUS
IR IN
MAIN ROOM
Main Room
789-44
Connecting Block
Emitter
4
Satellite Receiver
283D Emitter
DVD
283D Emitter
A/V Receiver
283D Emitter
Satellite Receiver
283D Emitter
Blu-ray
283D Emitter
A/V Receiver
286D
Smart TV Box