Pioneer FB009 Owner's Manual page 10

9.2 Malfunction of Remote Controller
Before sending in for service or repair, check the following points.
(Refer to Table 9-3)
Table 9-3
Symptoms
The fan speed cannot be
changed.
The remote controller signal is
not transmitted, even when
the ON/OFF button is pushed.
The TEMP. indicator does
not come on.
The indication on the display
disappears after a lapse of
time.
The TIMER ON indicator
goes off after a lapse of
certain time.
No receiving tone sounds
from the indoor unit, even
when the ON/OFF button is
pressed.
Causes
Check whether the MODE
indicated on the display is
"AUTO"
Check whether the MODE
indicated on the display is
"DRY"
Check whether the batteries
in the remote controller are
exhausted.
Check whether the MODE
indicated on the display is
FAN ONLY
Check whether the timer
operation has come to an
end, when TIMER OFF
is indicated on the display.
Check whether the timer
operation is started when
TIMER ON is indicated
on the display.
Check whether the signal
transmitter of the remote
controller is properly directed
to the infrared signal receiver
of the indoor unit when the
ON/OFF button is pressed.
Solution
When the automatic mode is
selected, the air conditioner will
automatically change the fan
speed.
When dry operation is selected,
the air conditioner automatically
changes the fan speed. The fan
speed can be selected during
"COOL" , "FAN ONLY", and "HEAT"
Use fresh batteries.
The temperature cannot be set during
FAN mode.
The air conditioner operation will
stop at the set time
Up to the set time, the
air conditioner will automatically
start, and the appropriate
indicator will go off.
Directly transmit the signal transmitter of
the remote controller to the
infrared signal receiver of the
indoor unit, and then repeatedly
push the ON/OFF button twice.