Other
Hints
on
Caring
for Your
Range
Lighted
Backsplash
Model
A509
_optlonal
accessory)
To turn
on the light:
Depress the ON positi0n (noted by raised dot
on switch); h0td in position momentarily and
release.
To replace
bulb:
Using both hands, rotate fluorescent tube a
quarter turn towards
you. Replace with a
similar size 24" CoolWhite Fluorescentbulb by
first insertingbulb prongs into sockets andthen
rotating towards the baoksplash.
To clean
backsplash:
Clean with mild detergent, 409, Grease Relief, or other nonabrasivecleansers. Do not clean with
abrasivecleansers or steel wool since these will scratch the finish.
To Replace
Oven
Light
Bulb
Before replacing bulb, disconnect power
to oven at the main fuse or circuit breaker
panel
Be sure
bulb
is cool
before
attempting
to remove. To obtain
firm
grasp on bulb, wear protective
rubber
gloves. Remove by turning bulb to the left.
Do not touch a hot oven light bulb with a
damp cloth as bulb will break. If the bulb
does break and you wish to remove it, be
certain power supply is disconnected and
wear protective gloves. You may contact
your
authorized
Jenn-Air
Service
Contractor for service.
Replace bulb with a 40-watt appliance bulb. Bulb with brass base is recommended to
prevent fusing of bulb into socket.
Access
Door
The access door is easily removed to
clean under the range if necessary. To
remove door, pull door down and lift off
pivot points. To replace door, slide door
over pivot points; lift up and insert prongs
into holes in the range.
To avoid the possiblity
of accidentally
disconnecting
any part of the ventilation
system, do not use the area behind the
access door for storage.
38