Monogramming And Embroidering With Embroidery Hoop - SPIEGEL SP3201 Operation Manual

a
a
b
a
b
1

Monogramming and embroidering with embroidery hoop

b
- Set the machine as shown.
- Remove the presser foot and the presser foot holder.
- Move the drop feed control to lower the feed dogs. (1)
- Lower the presser foot lever before starting to sew.
- Adjust the stitch width according to the size of lettering or design.
Preparation for Monogramming and Embroidering*
- Draw the desired lettering or design on the right side of the fabric.
- Stretch the fabric between embroidery hoop as firmly as possible.
- Place the fabric under the needle. Make sure the presser foot bar is
down in its lowest position.
- Turn the balance wheel towards you to bring up the lower thread
through the fabric. Sew a few securing stitches at the starting point.
- Hold the hoop with thumb and forefingers of both hands while pressing
the material with the middle and third fingers and supporting the
outside of hoop withe smaller finger.
* Embroidery hoop not included with machine.
a. Stitch width
b. Stitch length
38