Ipx5:4, Ipx10:4, Ipx10:8, And Ipx20:4 - Dynacord IPX5:4 Installation Manual

Ipx series dsp multichannel networking power amplifier
Table of Contents

Advertisement

IPX Series DSP Multichannel Networking Power
Amplifier
8.5

IPX5:4, IPX10:4, IPX10:8, and IPX20:4

DIGITAL SIGNAL PROCESSING
Sampling rate
Signal delay/latency
Analog In to Speaker Out, 48 kHz/96
kHz
Dante Network Latency
Signal Processing
User EQ
User Delay
Array EQ
Array Delay
Speaker EQ
Speaker X-Over
Speaker FIR
Speaker Limiters
Other Functions
Memory
DSP Presets
Speaker-Pool Presets
Source Supervision and Fallback
CONNECTIVITY
Network
Type
General
Network Audio Inputs
Network Audio Outputs (Monitor)
Mains Input
Bosch Security Systems, Inc.
48 kHz/96 kHz, OMNEO/Dante synchronized
0.70 ms/0.53 ms
typ. 1.00 ms
12 filters per channel, selectable as PEQ, Lo-Shelv, Hi-Shelv, Lo-ShelvQ,
Hi-ShelvQ, Hi-Pass, Lo-Pass and Notch; 2 filters of them with additional
asymmetric filter type
0 to 2000 ms per channel (units: µs, ms, s, cm, m, inches, feet)
5 filters per channel, selectable as PEQ, Lo-Shelv, Hi-Shelv, Lo-ShelvQ, Hi-
ShelvQ, Hi-Pass, Lo-Pass, and All-Pass
0 to 500 ms per channel (units: µs, ms, s, cm, m, inches, feet)
10 filters per channel, selectable as PEQ, Lo-Shelv, Hi-Shelv, Hi-Pass, Lo-
Pass and All-Pass
Hi-Pass, and Lo-Pass per channel, 6/12/18/24/30/36/42/48 dB Bessel/
Butterworth, 12/24/48 dB Linkwitz-Riley; Alignment Delay, 0 to 20 ms per
channel
Up to 1025 taps, Linear Phase Filter, Linear Phase Brickwall X-Over
Peak Anticipation Limiter and RMS/TEMP Limiter per channel
Source Selection and Mix, Level, Mute, Polarity, Sine and Noise
Generator, Pilot Tone Generator and Detection, Level Meters, Impedance
Measurement and Load Monitoring
1 Factory + 20 User
30 Speaker Settings
Pilot Tone supervision at Analog and OMNEO/Dante inputs, switchover to
alternative Source Selection
2 x Neutrik EtherCON/RJ45, redundant PRIMARY/SECONDARY
1000base-T/100base-TX, integrated switch
8 channels, 48/96 kHz, OMNEO/Dante format
2 channels, 48/96 kHz, OMNEO/Dante format
1 x Neutrik powerCON-HC
Installation manual
Technical data | en
27
2018.04 | 01 | F.01U.330.705

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ipx10:8Ipx10:4Ipx20:4

Table of Contents