Dynacord IPX5:4 Installation Manual page 22

22 en | Technical data
A-weighted, analog input
A-weighted, digital input
Output Noise
A-weighted, analog input
A-weighted, digital input
CONNECTIVITY
Analog Audio Input/Thru
Type
Maximum Input Level
Input Impedance, active balanced
Reference level equal to digital input
Speaker Output
GENERAL
Power Consumption
Rated power consumption (see BTU
table)
1/8 Maximum Output Power at 4 Ω
Idle Mode (no input signal)
Standby Mode
Dimensions
(W x H x D), mm
Weight
Shipping Weight
Amplifier at rated conditions, Low-Z Normal operation mode, all channels driven, 4 Ω loads,
Analog input, 32 dB Gain, 48 kHz sample rate, unless otherwise specified.
1 Test signal for max. output power according IHF-A-202 (Dynamic-Headroom, burst 1 kHz/20
ms on/480 ms off/low level -20 dB).
2 Available in Bridge operation mode only.
2018.04 | 01 | F.01U.330.705
< -70 dBu
< -73 dBu
2 x 6-pin Euroblock, male
+21 dBu
+21 dBu for 0 dBFS
1 x 8-pin Euroblock, 6 mm, female
483 x 88.1 x 514.2
15.0 kg (33.0 lb)
17.2 kg (37.8 lb)
Installation manual
IPX Series DSP Multichannel Networking Power
112 dB
115 dB
20 kΩ
1200 W
1765 W
80 W
< 16 W
Bosch Security Systems, Inc.
Amplifier