Dynacord IPX5:4 Installation Manual page 26

26 en | Technical data
A-weighted, analog input
A-weighted, digital input
Output Noise
A-weighted, analog input
A-weighted, digital input
CONNECTIVITY
Analog Audio Input/Thru
Type
Maximum Input Level
Input Impedance, active balanced
Reference level equal to digital input
Speaker Output
GENERAL
Power Consumption
Rated power consumption (see BTU
table)
1/8 Maximum Output Power at 4 Ω
Idle Mode (no input signal)
Standby Mode
Dimensions
(W x H x D), mm
Weight
Shipping Weight
Amplifier at rated conditions, Low-Z Normal operation mode, all channels driven, 4 Ω loads,
Analog input, 32 dB Gain, 48 kHz sample rate, unless otherwise specified.
1 Test signal for max. output power according IHF-A-202 (Dynamic-Headroom, burst 1 kHz/20
ms on/480 ms off/low level -20 dB).
2018.04 | 01 | F.01U.330.705
< -70 dBu
< -73 dBu
2 x 6-pin Euroblock, male
+21 dBu
+21 dBu for 0 dBFS
1 x 8-pin Euroblock, 6 mm, female
483 x 88.1 x 514.2
18.3 kg (40.3 lb)
20.5 kg (45.1 lb)
Installation manual
IPX Series DSP Multichannel Networking Power
115 dB
118 dB
20 kΩ
2250 W
2850 W
110 W
< 19 W
Bosch Security Systems, Inc.
Amplifier