TriTeq MicroIQ UT Installation Manual page 3

To unlock MicroIQ using a code:
When entering the Factory code, the Supervisor code or User code,
you should hear a 'click' sound, the green LED will light up turn the
knob to unlocked position.
As an option, the lock can be operated with the one blue remote key-fob and up to two black remote User key-fobs.
For further instructions about programming and operating the MicroIQ, please refer to the
watch the videos on our website, www.MicroIQLock.com
Care and Cleaning:
To clean the MicroIQ surface, apply a non-acid based cleaner to a clean cotton cloth. Do not spray
cleaner directly on the MicroIQ. Wipe down the keypad and housing surface of excess cleaner.
TriTeq Limited Warranty:
TriTeq offers a one year limited warranty all products to be free from manufacturing defects
in materials and workmanship. This limited warranty does not cover battery, lost combinations
or damages caused by improper mounting, improper or unreasonable use.
Liability Limits:
This is a limited warranty and in lieu of all other warranties (including the implied warranties
of merchantability and fitness of use) and under no circumstances shall TriTeq Lock & Security
or Hudson Lock, LLC be liable for any incidental or consequential damages or losses.
TriTeq Lock and Security
701 Gullo Ave
Elk Grove Village, IL
60007
Mounting Template
3
1
To re-lock MicroIQ:
Turn the knob from the unlocked position to the locked position,
listen for the lock mechanism to operate by hearing a "click"
sound, confirm the knob is locked.
Phone: (847) 640-7002
Toll Free: (888) 603-5625
Email: marketing@triteqlock.com
3.150
.75
1/8" diameter hole for metal
3/32" diameter hole for wood
1.00
"MicroIQ Programming" manual or
Operating Temperature: 0 - +50 C
Storage temperature: -10 - +70 C
Operating Moisture: 20% - 80% Rh
Replacement Battery: 3 volt lithium CR2032
Battery Life: 3 to 5 years typical or 50,000 operations
ATTENTION: Battery life may vary with battery brand
and environmental conditions.
© Copyright 2014 TriTeq Lock and Security. All rights reserved
Measure before drilling.
If the length of the segment is di erent from 1.00"
the template dimensions will be scaled accordingly
(without condensation)
13018 - Rev. 3 S-L