Advertisement
The above data is for basic reference only It is strongly recommended to use the correct EMC
filter and screened/armoured cable (not shown).
WARNING: THIS EQUIPMENT MUST BE EARTHED
If in doubt consult IMO or VXR instruction manual
As shown at the right, the keypad
7-segment LED monitor
consists of a four-digit LED monitor,
six keys, and five LED indicators. The
keypad allows you to run and stop
the motor, monitor running status,
and switch to the menu mode. In the
Program /
menu mode, you can set the function
Reset key
code data, monitor I/O signal states,
maintenance information, and alarm
Function /
Data key
information.
UP key
LED Monitor, Keys,
Item
Functions
and LED Indicators
Four-digit, 7-segment LED monitor which displays the followings according to the operation
modes.
Running status information (e.g., output frequency, current,
LED
In Running mode:
and voltage)
Monitor
In Programming mode:
Menus, function codes and their data
Alarm code, which identifies the alarm factor if the protective
In Alarm mode:
function is activated.
Program/Reset key which switches the operation modes of the inverter.
In Running mode:
Pressing this key switches the inverter to Programming mode.
In Programming mode:
Pressing this key switches the inverter to Running mode.
Pressing this key after removing the alarm factor will switch the
In Alarm mode:
inverter to Running mode.
Function/Data key which switches the operation you want to do in each mode as follows:
Pressing this key switches the information to be displayed
In Running mode:
concerning the status of the inverter (output frequency (Hz),
Operation
output current (A), output voltage (V), etc.).
Keys
Pressing this key displays the function code and sets the data
In Programming mode:
entered with and keys.
Pressing this key displays the details of the problem indicated by
In Alarm mode:
the alarm code that has come up on the LED monitor.
RUN key. Press this key to run the motor.
STOP key. Press this key to stop the motor.
UP and DOWN keys. Press these keys to select the setting items and change the function
code data displayed on the LED monitor
Menu
Menu
LED indicators
0
Quick Setup
RUN key
RUN LED
1
Data Setting
STOP key
DOWN key
2
Data Checking
3
Drive Monitoring
4
I/O Checking
5
Maintenance Information
6
Alarm Information
Selecting menus to display
Data for E52
0
1
2
If in doubt consult IMO or
VXR instruction manual
LED Display
Main Functions
0.Fnc
Displays only basic function codes to customize the inverter operation.
1.F##
F codes (Fundamental functions)
1.E##
E codes (Extension terminal functions)
1.C##
C codes (Control functions)
1.P##
P codes (Motor 1 parameters)
Selecting each of these
H codes
function codes enables
1.H##
(High performance functions)
its data to be displayed /
changed
1.A##
A codes (Motor 2 parameters)
1.J##
J codes (Application functions)
1.J##
y codes (Link functions)
1.O##
o codes (Optional function)
Displays only function codes that have been changed from their factory
2.rEP
defaults. You can refer to or change those function code data.
Displays the running information required for maintenance or test
3.oPE
running.
4.i_o
Displays external interface information.
5.CHE
Displays maintenance information including cumulative run time.
Displays the recent four alarm codes. You can refer to the running
6.AL
information at the time when the alarm occurred.
Mode
Menus selectable
Menu #0 Quick Setup
Function code data editing mode (factory default)
Menu #1 Data Setting
Function code data check mode
Menu #2 Data Checking
Full-menu mode
Menus #0 through #6
Advertisement
