Qsonica Q700 Operation Manual page 18

The follow ing screen displays the Manual Mode.
A
B
C
D
A. Microtip Mode – Indicates that the unit is set for use w ith microtips only. This mode
should not be used w it h standard probes or horns (1/2" or larger). See page 15 for
information on selecting YES or NO at the " Are you using a M icrotip screen" .
B. Amplitude (intensity) setting - Output amplitude may be set betw een 1 -100% .
C. Pow er displayed in Watts.
D. Energy displayed in Joules.
E. Elapsed Time – Total time of active sonication.
F. Temperature probe measurement (note: if " OPN" appears, it indicates temperature
monitoring has been activated but the probe is not connected).
G. Temperature probe On/Off indicator. Touch the box to activate temperature
monitoring. A check mark w ill appear indicating that temperature monitoring is activated.
Select the appropriate Amplitude (intensity setting) for your sample by touching t he Up or
Dow n arrow . Touch St art to begin sonication. Touch Pause to pause sonication.
Manual and Program modes bot h show the Start, Pause and Exit buttons. After touching
the Start button and activating sonication, the Start button becomes a Stop button. After
touching the Pause button, the Pause button becomes the Resume butt on.
If sonication is stopped, Energy and Elapsed Time values remain on display. If the Start
button is t ouched again, the values are reset. If sonication is Paused and Resumed, the
Energy and Elapsed time data w ill resume counting from the point at w hich it w as paused.
The Temperature Probe option can be selected if you w ish to monitor t he temperat ure of
the sample being processed.
18
E
F
G
Rev. 6-12