General Introduction To The Controller Interface - Gram BIOBASIC 210 User Manual

Start up

General introduction to the controller interface

Turn On/Off:
Press shortly
the cabinet off.
Initiation procedure:
Readout of the software version and variant will occur shortly after
turning the cabinet on. The cabinet will then automatically start a
defrost-cycle, and terminate it again after a system check.
The cabinet is ready when the temperature is displayed.
The cabinet will always commence operation when initially connected
to a power supply. For instance after a power outage or when plugging
the cabinet in for the first time.
Setpoint temperature adjustments:
Temperature adjustments are done by pressing
prompting the set point temperature. Adjust the set point temperature
by either pressing
Servicing:
Make sure the appliance is switched off at the socket before service is
performed on the cabinet. It is not sufficient to switch off the cabinet on
the On/Off button, as current will persist in some electrical parts of
the cabinet.
If fuses or similar are to be replaced, the appliance must be moved to a
no-risk area for safe replacement.
16 |
BIOBASIC MANUAL
to turn the cabinet on and press for 6 seconds to turn
or . Confirm the settings by pressing
for 3 seconds,
.