Electrical Connection - Miele ESW 6114 Operating And Installation Instructions

Electrical connection

All electrical work must be carried out
by a suitably qualified and competent
person in strict accordance with current
local and national safety regulations.
Connection should be made via a
switched socket. This will make it easier
for service technicians should the
appliance need to be repaired. The
electrical socket must be easily
accessible after installation.

Danger of injury!
Miele cannot be held liable for
unauthorised installation,
maintenance and repair work as this
can be dangerous to users.
Miele cannot be held liable for
damage or injury caused by incorrect
installation, maintenance or repair
work, or by an inadequate or faulty
earthing system (e.g. electric shock).
If the plug has been removed or the
connection cable is not supplied with
a plug, the drawer must be
connected to the mains supply by a
suitably qualified electrician.
If the appliance is to be hard-wired,
an additional means of
disconnection must be provided for
all poles. When switched off, there
must be an all-pole contact gap of at
least 3 mm in the switch (including
switch, fuses and relays). Connection
data is shown on the data plate. It
must match the mains electrical
supply.
After installation, ensure that all
electrical components are shielded
and cannot be accessed by users.
52
Total power output
See data plate.
Connection and fuse rating
AC 230 V, 50 Hz
The voltage and rated load are given on
the data plate. Please ensure these
match the household mains supply.
Residual current device
For extra safety, it is advisable to install
a residual current device (RCD), with a
trip current of 30 mA. Do not connect
the appliance via an extension lead.