Kioti KRX19542H Operator's Manual page 30

6. MAINTENANCE (cont.)
If the battery is not removed from the machine, make sure that the key on the
control panel is in the "OFF" position. Connect the battery charger to the mains
power supply and then attach the connector (2):
-to the corresponding connector of the machine's wiring (if fitted)
-or otherwise to the wire (3) with the serrated-edge grips, attaching
theses to the terminals of the battery in the following sequence:
1- first the red grip to the positive terminal (+)
2- and then the black grip to the negative terminal (-).
The battery charger LED lights (4-5-6) (see previous page) show the type of
functioning:
4- Green = Battery charger live
5- Yellow = Charging at 14.7 Volts
6- Yellow = Maintenance charge at 13.6 Volts
whether they are lit
-normal condition:
-
normal charging of a partilly
discharged battery.
-
particular condition:
-
if, after a few
minutes it becomes...
-
on being
connected
-
the battery is insufficiently recharged in the 48 hours and requires a second
charging cycle by disconnecting and reconnecting after 5 seconds the battery
charger to the mains power supply. When another 24 hours have passed, if the
LED (5) does not go out it means that the battery is damaged beyond repair and
cannot take the recharge.
-
for about
30 seconds
27
or off signals:
-
possible inversion of terminals in connecting the grips;
-the battery is in a deep discharge connection and is being slowly
regenerated. The true charging takes place when the LED (5)
lights up after a few hours.
-
the thermal
protection
device has
cut in.
-
the battery is on
48 hours
maintenance charge.
after being
connected.
-
the battery has already been
sufficiently charged before the
48 hours.
- -
continuous no power being
supplied or battery
charger faulty