Kioti KRX19542H Operator's Manual page 29

This battery charger supplied with some models must only be used for keeping
charged 12 Volt lead/acid batteies, either sealed (acid level maintenance free) or
traditional, with a maximum capacity of 30 Ah. In cases, it can also be used for
emergency charging.
Carry out the recharging operation at ambient temperature between 0 and 38
degrees celsius, strictly complying with the recommendations shown in the
instructions for using the battery and the machine in which it is fitted.
Do not use the battery charger if damaged, or in case of doubt about its
efficiency after being knocked or a fall.
Do not dismantle the battery charger or alter its characteristics.
The battery charger kit (1) includes:
-a two-core cable with a connector (2) for connecting to the wiring of machines
that include this possibility;
- a two-pole wire (3) with serrated-edge grips.
The battery charger has been specifically developed to keep up sealed batteries,
maintaining the charge during periods of inactivity. Used regularly, it will assure
longer life & efficiency to the battery, preventing it from being damaged by deep
discharging over extended periods.
When connected, the battery charger supplies current at a constant 14.7 volts
After 46-48 hours, a built-in timer will switch the voltage from 14.7 to 13.6 V which
will assure the maintenance of the charge until such time as the battery charger is
disconnected.
If the machine is only occasionally used, the battery can be charged before and
after each use, or otherwise it can even be left charging for some months
between one use and another.
Connect the battery charger to
a power outlet which has the
same voltage and frequency
as that shown on the plate.
If the extension cables are
used, these must have plugs
complying with laws. Place the
battery charger in a stable ,
dry and clean location and
prevent both the battery
charger and the cable from
coming into contact with water
or dirt.
26