Kioti KRX19542H Operator's Manual page 11

3.5 FITTING THE FRONT BUMPER
3
2
1
3.6 FITTING THE SIDE DISCHARGE CHUTE (STONE GUARD)
1 2a
2
1
Fit the pin (4) in the holes on the
brackets (3) & on the stone-
guard, so that it passes thrugh
the coils of the spring (2) & the
drilled end comes out of the inner
most bracket.
2
3
Fit the cotter pin (5) in the hole
(4a) of the pin (4) & turn the pin
until the two ends (5a) of the split
1
pin can be bend (using pliers), so
that it cannot slip out and let the
pin fall out (4).
WARNING!
Check that the spring works correctly and keep the stone-guard securely lowered.
2 Make sure that the pin is fitted properly to prevent it from falling out accidently.
Do not use the machine without the Side Discharge Chute (Stone -Guard) (1)
correctly fitted. The Side Discharge Chute must be fitted at all times, regardless of
the use of a mulching plug.
5
4
Inside the stone-guard (1), fit the spring (2) by inserting
the terminal (2a) into the hole and turning it so that both 171505434/0
the spring (2) and the terminal (2a) are securely
positoned in their seatings.
Position the stone-guard (1) in line with the cutting deck
brackets (3). Using a screwdriver, turn the second
2
terminal (2b) of the spring (2) to bring it outside the
stoneguard.
2b
5
4a
4
Fit the Front Bumper (1) onto the chassis
mounting holes (5) and fasten in place
using screws (2) four places.
Note that access can be improved by
temporarily removing the Hood Bonned from
the Hinge (3), or by turning the steering
wheel to adjust the position of the wheel (4).
WARNING!
machine without the Front Bumper (1)
correctly fitted to the chassis (5)!
2b 2
2b
4
4
3
3
5
4a
4
1 2a
Do not use the
1 2a
2
2
2
2b
1
1
3
2
3
1
1
2
2
5a
5a
2
2b
8