Kioti KRX19542H Operator's Manual page 10

3. UNPACKING AND ASSEMBLY (cont.)
5
1
2
3
3
4
IMPORTANT
in the battery's manual (
IMPORTANT
from cutting in, never start the engine until the battery is fully charged!
WARNING!
battery incorrectly fixed in its housing.
7
8
7
6
2
1
Always fully charge the battery according to the instructions
6.2.5).
To prevent the safety device in the electronic circuit board
Do not use the machine without the spring (2) or with the
Fit the steering wheel (5) onto the
hub (1) with the spokes directed
towards the seat.
Fit the spacer (6) and fasten the
steering wheel in place using the
screws supplied (7), in the indicated
order.
Fit the steering wheel cover (8)
clicking the three fasteners into place.
3.3 FITTING THE SEAT
Mount the seat (1) on the plate (2)
using the screws (3).
3.4 ASSEMBLY & CONNECTING
THE BATTERY
The battery (1) is housed under the
seat and secured by a spring (2).
1
First connect the red wire (3)
3
to the positive pole (+) and
5 then the black wire (4) to the
negative pole (–), using the
screws supplied as shown.
Apply silicone grease to the
terminals and check that the
protective cap for the red wire
(8) is in place.