Batteries And Charger; Wrist Strap And Belt Clip; Installation - Cobra MR HH 500 FLT BT EU Owner's Manual

Vhf marine radio
Table of Contents

Advertisement

Wrist Strap and Belt Clip

Installation

VHF Marine Radio Protocols
Wrist Strap and Belt Clip
Belt Clip
Belt Clip
Use the spring-loaded belt clip to carry the radio on your
person.
1. Slide the belt clip into the guide channel on the back of the
radio until it is locked in place.
2. To attach the wrist strap, insert it through the hole at the
top of the belt clip, feed it through the looped end and pull
tight to secure to the belt clip.
Insert Belt Clip onto Radio
3. Press open the belt clip, slide it over the belt and release
the clip.
4. To remove the belt clip from the radio press the tab on the
belt clip, which unlocks the clip, and slide it out.
Wrist Strap Attachment
Secure Radio
English
8

Batteries and Charger

Installation
VHF Marine Radio Protocols
Initial Charge
Power Sources
The Cobra-provided LiON battery pack may be charged at
home, in a car or in a boat using the appropriate 12V or
220V power cord with the charger.
1. Insert one (1) of the power cords into the back of the
drop-in charger.
2. Insert the other end of the power cord into the appropriate
12V or 220V power source.
3. Remove battery pack spacer from the charger and insert
Initial Battery Charge
the entire radio/battery into the charger. The metal charge
contacts on the battery will contact the mating prongs in
the charger to transfer the charging current.
4. Observe that the red light on the front of the charger
glows to indicate that the battery pack is properly seated
and the charger is operating.
5. Allow the batteries to charge for five (5) to six (6) hours
before use. The light will change back to green when the
battery is fully charged.
WARNING
Only the rechargeable LiON battery pack can be
recharged. You MUST use one of the charging devices
provided with this radio. Do not substitute any other
type of charging adapter or charger base for this
radio. Battery damage, fire or explosion may result.
It is equally important to prevent the lithium-ion
(LiON) battery pack from freezing to obtain best
performance from the battery pack.
NOTE
If the drop-in charger is used on a boat, Cobra
recommends you attach it to a horizontal shelf or
vertical bulkhead (using the screw holes provided)
to prevent possible damage due to the boat rolling or
pitching. The charging base has been designed to hold
the battery pack in place during rough sea conditions.
Nothing Comes Close to a Cobra
®
9

Advertisement

Table of Contents
loading

Table of Contents