Cobra MR HH 500 FLT BT EU Owner's Manual page 18

Advanced Operation
Operating Your Radio VHF Marine Radio Protocols
Using Tri-Watch
TRI-WATCH Button
CAL
Tri-Watch Scan Mode:
ENT SE
1. From Marine Standby mode, press the TRI-WATCH
TW
button. The TW SCAN will display on the matrix
along with the three marine channels stored in the
MEM
Tri-Watch memory.
ESC
2. The radio will scan through the three (3) Tri-Watch
memory channels.
Tri-Watch Scan Mode
3. A signal on any one (1) of the three (3) channels will
GMRS
stop the scan for 10 seconds to allow you to listen to
VHF
R
X
the traffic on that location.
T
A
NOTE
B
U I C
ATIS VOX LOMEDHI SAME MEM After the Tri-Watch scan stops to monitor a channel,
as long as you do not press any buttons within 10
seconds, your radio will automatically resume
scanning the Tri-Watch channels. Channel 16 is given
priority in Tri-Watch Mode.
4. Press the Channel Up/Down button to resume
scanning the Tri-Watch channels or to change the
scan direction.
5. To EXIT the Tri-Watch scan, press the TRI-WATCH
button again, and the radio will return to Marine
Standby mode.
30 English
Advanced Operation
Operating Your Radio VHF Marine Radio Protocols
C
ENT SETUP
Memory Location Mode
MEM/ESC Button
Your radio has unlimited memory locations for storing your
most frequently used channels. These memory locations can
MEM
be selected individually or can be scanned. (See page 34
ESC
under Memory Location Scan.)
To enter Memory mode, press MEM/ESC button. The display
will show the MEM icon and the Memory Channel bank will
be displayed on the matrix.
Memory Location Number
To Program Memory Locations:
GMRS
VHF
R 1. Press and hold the MEM/ESC button for two (2)
X
T
seconds. The memory location number will be
A
displayed on the matrix and the MEM icon will be
B
U I C
turned On.
ATIS VOX LOMEDHI SAME MEM
2. Use the Channel Up/Down button to advance to the
memory location (00-99) you want to program.
Channel Up/Down Buttons
MARINE HH50
3. Press the MEM/ESC button to select the memory
location.
4. Use the Channel Up/Down button to change to the
channel you want to store into the selected memory
location.
CALL
5. Press the MEM/ESC button to program that channel.
ENT SETUP
The memory location will be displayed on the matrix
again.
Channel Number
Repeat steps 2 through 5 to program as many
GMRS
VHF
additional memories as you want.
R
X
T
6. Press and hold the MEM/ESC button for two (2)
A
seconds. This will return the radio to Memory mode.
B
U I C
ATIS VOX LOMEDHI MEM
7. Press and release the MEM/ESC button again to
return to Marine Standby mode.
Nothing Comes Close to a Cobra ® 31