Furuno SC-33 Operator's Manual page 8

1. OPERATIONAL OVERVIEW
2. Turn the power on the SATELLITE COMPASS
Note: When multiple SATELLITE COMPASS
work, the SC setting tool cannot find and connect to the SATELLITE COMPASS
Disconnect all SATELLITE COMPASS
es do not need to be disconnected.
3. Activate the executable file of the SC setting tool (file name: "SC_Setting_Tool.exe") on your
PC.
The [Select Device] dialog box appears.
4. Set the following items, referring to the following table.
Menu Item
Select Device
Equipment Identification
NMEA2000 Select Driver
Select Channel
Select Unique
Number
NMEA0183 Select Driver
Select Baudrate
Screenshot
Connect
™
that you want to setup.
™
are connected in the same NMEA2000 net-
™
except the unit to be setup. Other NMEA2000 devic-
Select the model number to be connected.
Select the equipment ID of the SATELLITE COMPASS
nected. The default equipment ID is "1". For the initial setting, select
"1". If the equipment ID has been changed from the default, you
should select the appropriate equipment ID, according to the set-
ting on the [Sensor Setup] tab (see section 2.3 ) .
Select the driver type. Driver type depends the CAN-USB converter
to be used.
• For CANUSB: Select [CanUSB.dll].
• For USBcan II: Select [KVASER.dll].
Select the channel name for CAN connection. The channel name
shown in the drop down list changes according to the CAN-USB
converter to be used.
Assign a unique identification number to the PC (default setting: [0
(Default)]). Setup this menu item only when you connect multiple
PCs in the same NMEA2000 network. Be sure to assign a different
number to each PC.
Not used. Reserved for future use.
Not used. Reserved for future use.
Capture the screenshot of the [Select Device] dialog box (file for-
mat: bit map). When you click the [Screenshot] button, the file des-
tination setting dialog box appears. Enter the file name and file
location to save the screenshot.
Connect the SATELLITE COMPASS
lect Device] dialog box. The [SC_Setting_Tool] dialog box appears
after clicking the [Connect] button.
3
Remarks
™
to be selected on the [Se-
™
correctly.
™
to be con-