How To Select The Mask Type; Smartstart - ResMed VPAP AUTO 25 User Manual

How to Select the Mask Type

Scroll to MASK and select
require. The following table shows the setting that should be selected for each mask:
Settings
ULTRA
MIR FULL
ACTIVA
SWIFT
STANDARD
MIRAGE
How to change the EPR level (CPAP mode)
Expiratory Pressure Relief (EPR) can be used to improve your comfort level when
breathing out during treatment. If patient access is enabled by the clinician you can
change the EPR level. There are four settings: OFF; 1 (lowest EPR); 2; and 3 (highest
EPR).
1
On the standby (RAMP) screen, press
2
Press
3
Press
4
Press
How to change the Exhalation rate (VAuto mode)
If patient access is enabled by the clinician, you can adjust the Exhalation rate so that
the rate of pressure drop is at a level that is most comfortable for you. There are three
settings: Fast; Medium; and Slow.
1
On the standby (SETTLE) screen, press
2
Press
3
Press
4
Press

SmartStart™

If your clinician has enabled SmartStart/Stop, your device will start automatically
when you breathe into your mask and stop automatically when you take your mask
off.
6
. Press
Mask
Ultra Mirage Nasal Mask
Ultra Mirage II Nasal Mask
Mirage Liberty Full Face Mask
Mirage Quattro Full Face Mask
Ultra Mirage Full Face Mask
Mirage Activa Nasal Mask
Mirage Swift Nasal Pillows System
Mirage Swift II Nasal Pillows System
Swift LT Nasal Pillows System
Mirage Vista Nasal Mask
Mirage Micro Nasal Mask
Mirage Nasal Mask
until you see EPR LEVEL, then press
or until you see the setting that you require.
to save the setting.
until you see EXHALATION, then press
or until you see the setting that you require.
to save the setting.
or until you see the setting you
.
.
.
.