Renesas Emulation Pod M306N4T3-RPD-E User Manual page 35

Table 3.3 Switch settings of the M306N4T3-RPD-E (2/4)
Signal Switch
Xout SW3
P86/Xcout SW4
P87/Xcin SW5
Note on Switch Settings:
• Always shut OFF power before changing switch settings.
Note on BYTE and CNVss Switch Settings:
• Switch settings of the BYTE and CNVss are for debugging without the target system
connected.
Setting
SW3
Does not connect pin Xout of the MCU to the target
system.
(Factory-setting)
SW3
Connects pin Xout of the MCU to the target system.
Connects pin P86/Xcout of the MCU to the target
system to use it as port P86 or Xcout.
SW4
(Factory-setting)
Does not connect pin P86/Xcout of the MCU to the
target system.
SW4
Uses pin P87/Xcin of the MCU as port P87.
SW5
(Factory-setting)
Uses pin P87/Xcin of the MCU as Xcin.
SW5
CAUTION
IMPORTANT
( 35 / 76 )
Description