Casio DT-X8-20C-CNV Hardware Manual page 21

DT-X200 Hardware Manual
No. Name
1 Speaker
2 Indicator 1
3 Indicator 2
4 Touch Screen
5 Cursor Keys
6 Center Trigger Key
7 Power Key
8 R Key
9 L Key
10 Execute Key
11 Numeric Keys
12 Function Keys
13 Microphone
14 Fn Key
15 CLR Key
16 Strap Holes
17 micro SD Card Slot
18 R Trigger Key
19 L Trigger Key
20 USB and Charging Unit
Mount Holes
21 Reader Port
22 Hand Belt Setting part
23 Extension Port
24 Battery Pack Cover Lock
Switch
25 Cradle Mount Holes
26 Battery Pack Cover
27 Reset Switch
28 Power/Signal Terminals
Description
Buzzer and voice messages are output.
Orange : Charging battery pack.
Green : Charging battery pack is complete.
Red : Battery pack is abnormal or the surrounding temperature is out of
the charging temperature range.
Flashes in blue when operating via Bluetooth or in orange when operating via
WLAN. Lights in green when reading a bar code successfully or in red when
alarming or in magenta when available to communicate or in light blue when
resume (programmable).
Displays text and operating instructions. Also used to operate the terminal and
enter data using stylus provided.
These keys operate much like PC's cursor keys.
Used to perform bar code reading. Can be assigned an arbitrary function.
Turns on and off the power.
Available to set any function.
Available to set any function.
Press when finishing entering numerical values or when moving to the next
step.
Used to enter numeric, decimal points, and letters.
Various functions other than bar code reading can be assigned to these keys.
The assignments by default on the keys are as follows.
F1: Deletes the character on the left side of the cursor.
F2: Not assigned
F3: Not assigned
F4: Inputs "-" (minus).
F5: Inputs a space.
F6: Not assigned.
F7: Not assigned.
F8: Changes text input mode. The input mode navigates to Numeric 
Uppercase letter  Lowercase letter.
Used to input a sound including voice sound. See note.
Used to make various settings in combination with the function keys or
numeric keys or when starting a pre-registered application.
Used to clear one letter to the left of the input key.
Used to attach the hand strap. Also used for the hand belt.
For insertion of a micro SD card into the slot in the battery compartment.
Used to perform bar code reading.
Used to perform bar code reading.
Used to perform to set DT-X8 into "USB and Charging Unit".
Laser light (Laser scanner models) or LED light (C-MOS Imager models) is
emitted from this port that reads bar codes.
Used to set Hand Belt in this position.
Provided for connecting an external device.
Used to lock the battery cover and to release it.
Used to mount the terminal in cradle.
Used to cover the battery compartment that holds the battery pack inside.
Used to reset the terminal.
Used for USB communication or to supply power to the terminal and to charge
the battery pack via Cradle.
CASIO COMPUTER CO., LTD.
P.21