Omron BL50T Instruction Manual page 9

Make sure of setting up the earth connection (grounding.)
● Check the shape of the power outlet's plug, and insert the UPS's "AC input" plug
as-is.
Without an earth connection, the unit can fail or cause an electric shock due to the
electric leakage.
Do not disassemble, repair, or modify.
● Electric shock or fire can occur.
Do not install in an undesignated direction.
● There is a risk of injury if the product falls or drops.
● Do not install in the direction other than specified; otherwise, the battery leakage
cannot be treated.
Do not use the UPS in an environment where the highest temperature
becomes more than 40°C.
● Otherwise, the battery may deteriorate rapidly and cause fires.
● The UPS may fail or malfunction.
The use and storage environment should be in the specification scope.
Do not install or store in the following places.
● Do not store at the places where the humidity is lower than 10% or higher than
90%.
● Do not use at the places where the ambient temperature is lower than 0 degrees
Celsius or higher than 40 degrees Celsius. (No condensation)
● Do not use at the places where the humidity is lower than 25% or higher than 85%.
● Do not use or store at the following places: sealed places such as a cabinet without
gap; places where a flammable gas or corrosive gas exists; places that are
extremely dusty; places that are exposed to direct sunlight; places where vibrations
or impacts may occur; places where sodium content and water droplets exist;
outdoors; and others
● Failure to observe the above may cause an accident such as a fire.
Do not connect the devices that exceed the output capacity of the UPS.
You can add a connected device by using a power strip. In such a case,
make sure that when a connected device is added, the current capacity
of the power strip is not exceeded.
● The UPS detects overload and stops its output operation.
● The table tap wiring may catch the heat and cause a fire.
Do not pull a cable.
To use a cable, do not pinch or forcibly bend it.
Do not use a folded cable.
● Electric shock or fire can occur due to the cable damage or overheat generation.
● Stop using the UPS if the cable has damage and immediately ask for the repair.
For information about repair, contact Omron Electronics Repair Center.
All the accessories contained in the product package can be used for
the UPS only. Do not use any of them for other devices.
● Make sure of observing the followings for the safe use of equipment.
BL50T/BL75T/BL100T
Caution
(at installation and connection)
Safety Precautions
9