Advertisement
27. The first time the E8 is used the following dialog appears: Otherwise skip to step 31.
28. Click <OK>.
29. Select "Renesas E-Series USB Driver". Select "USB Interface". The channel number will vary.
30. Click <Close>.
31. Accept any dialogue warning that an older version of E8 firmware is necessary to work with the application.
Allow download of firmware to complete, this may take several seconds.
32. Select "Power supply is carried out" if the E8 is to provide the power to the RSK board. Otherwise connect a 5V
center positive supply.
33. Select "5V" then click <OK> if "Power supply is carried out" is selected, otherwise click <OK>.
34. Enter "User Flash Area" for the firmware location. Click <OK>. The flash memory write program and E8 monitor
are then downloaded to the microcontroller.
Advertisement
