Connecting An Rps Power Cord - HP FlexNetwork MSR3064 Installation Manual

Loosen the captive screws on the power supply with a Phillips screwdriver to remove the power
2.
supply connector.
Connect one end of the DC power cord supplied with the router to the DC receptacle on the
3.
router.
Connect the other ends of the wires to the DC power source wiring terminals, with the negative
4.
wire (– or L–) to the negative terminal (–) and the positive wire (+ or M/N) to the positive terminal
(+).
Figure 46 Connecting a DC power cord for an MSR3012/3024
Figure 47 Connecting a DC power cord for an MSR3044/3064

Connecting an RPS power cord

The MSR3012 and MSR3024 offer remote power supply (RPS) support. As an external power supply,
RPS can provide power supply for the device in case of power supply abnormality. It enhances the
reliability of the device.
The router has a sticky label and a protective cover when shipped to protect the RPS receptacle.
To connect an RPS power cord:
Remove the sticky label.
1.
2
2
35
1
1