Table of Contents
Advertisement
Bending Leaf Pivot Bushings
Oil Type ................ SB1365 or ISO 68 Equivalent
Oil Amount ..................................... 1 or 2 Squirts
Lubrication Frequency ................................. Daily
The bending leaf rotates around the pivot shaft on
bushings that require lubrication. Use an oil can to
add lubricant to the hole shown in Figure 26 (one
on each side of the bending leaf), then raise and
lower the bending leaf several times to distribute
the lubricant.
Figure 26. Hole for lubricating bending leaf pivot
bushing.
Bending Leaf Cam
Grease .................. T26419 or NLGI#2 Equivalent
Amount .................................................Thin Coat
Lubrication Frequency ..............................Weekly
Use mineral spirits and a shop rag to clean each
side of the cam (see Figure 27), then apply a
thin coat of grease to each side. Raise and lower
the bending leaf several times to distribute the
lubricant.
Bending Leaf Cam
Figure 27. Bending leaf cam location.
-22-
Hole for Oil
(1 of 2)
Setback Shafts
Oil Type ................ SB1365 or ISO 68 Equivalent
Oil Amount .................... 1 Drop at Each Location
Lubrication Frequency ..............................Weekly
Raise the bending leaf until it is parallel with the
floor, then add one drop of oil to the setback shaft
locations shown in Figure 28. Use the setback
adjustment knobs equally to move the bending leaf
back and forth along the shafts to distribute the
lubricant.
Lubrication Points
Figure 28. Example of setback shaft lubrication
locations.
Model T28325 (Mfd. Since 1/18)
Advertisement
Table of Contents
