Device Description; Bikepilot² - Blaupunkt BikePilot2 User Manual

1. Device description

1.1 BikePilot²
Charging light
Settings
Record track
Power button
Power button: Switches the device on. When you press the power button during use, you have the following
options:
Switch off: Switches the device off completely.
Stand-by: Switches to stand-by mode.
Screen off: The screen is switched off, ongoing navigations or activity recordings are retained.
Keylock on/off: Activates or deactivates the keylock. The keylock prevents unwanted entries being made via
the screen. To deactivate the keylock, press the power button again and then press Keylock.
takes you back to the application.
Charging light: The device is equipped with a charging light. When the device is connected to a power source
for charging, the lamp is lit red. When the device is fully charged, the charging lamp lights up green.
Note: If the device stops responding and can no longer be operated, perform a reset on the device: Open the
cover for the USB / Micro SD card slot and insert a paper clip into the small opening above the SD card slot.
Note: The device cannot be switched off while it is being charged via the USB port.
Record track button: Starts or pauses the recording of an activity or a timed route. If you press it for a long
time during a recording, the track recording can be stopped and saved.
Screen: Displays the map and the menu. To make entries or select functions, use your finger to tap on the
appropriate point on the screen.
6