Lenovo ThinkSystem NE2572 Installation Manual page 67

3. Set the new switch to use the Machine Type-Model (MTM) number of the old unit.
For example:
4. Set the new switch to use the serial number of the old unit. For example:
5. Reset the switch using the following command:
6. When prompted for confirmation, enter y. The switch will then restart.
7. After the switch reboots, return to the command prompt and verify that the VPD
information is correct using the following command:
© Copyright Lenovo 2018
NE2572(config)# hardware mtm 1234-56X
New MTM value: 1234-56X
Please reset the system for the new changes to take effect
where 1234-56X is the MTM from your old unit.
Note: The MTM shown here is merely an example. Use the actual MTM recorded
from your old NE2572 unit.
NE2572(config)# hardware esn XX01234567
where XX01234567 is the serial number of your old unit.
Note: The serial number shown here is merely an example. Use the actual serial
number recorded from your old NE2572 unit.
NE2572# reload
NE2572> display sys-info
*** display boot ***
Current ZTP State: Enable
Current FLASH software:
active image: version 10.4.2.0
standby image: version 10.4.2.0
Uboot: version 10.4.2.0
Currently set to boot software active image
Current port mode: default
Currently scheduled reboot time: none
...
System Name:
System Description:
System Model:
System Manufacture Date:
System Serial Number:
...
For more information about using the switch interface, see the Application Guide and
Command Reference for the NE2572 and its corresponding Lenovo Network
Operating System and firmware version.
NE2572
NE2572
LENOVO NE2572
1304
XX01234567
Chapter 4: Removing and Replacing Components
67