Lenovo ThinkSystem NE2572 Installation Manual page 41

1. Locate, record, and retain the product switch information in order to configure and
register your product. See
2. Attach the front mounting brackets (Item 1) to each side of the switch with M4
screws (Item 2). Torque the screws to approximately 2.0 newton-meters (Nm) ± 0.1
Nm (17.7 inch-pounds).
© Copyright Lenovo 2018
To install the NE2572 in a System x or Power rack, complete the following steps:
Note: If this switch is a replacement switch, copy the product information from the
original switch onto the RID label that is shipped with replacement switch and
affix the new label to the bottom of the new switch.
1
"Before Installing the NE2572" on page
Chapter 3: Installing NE2572 Hardware and Options
32.
1
2
41