Visonic SD-304C PG2 Installation Instructions Manual

SD-304C PG2
PowerG, Wireless Shock and Contact detector with Wired Input
1. INTRODUCTION
The SD- 304C PG2 is a wireless PowerG innovative shock detector with optional magnetic contact and auxiliary input interfacing with all PowerMaster
control panels, version 16 or higher. The SD-304C PG2 fits windows, doors, walls or roofs and is ideal for residential or commercial installations. It
detects and analyzes gross attacks or a series of low level shocks and provides early warning of any attempt of intrusion before a burglar actually breaks-
in.
The detector incorporates:
A shock / vibration piezoelectric sensor.
l
Optional reed switch (with optional anti-mask sensor to prevent attempts at disabling it with an extra magnet).
l
Optional auxiliary input to use with installer supplied contacts or other wired devices.
l
Installer added-value features:
Digital display enables fast and easy shock level adjustment
l
Full remote configuration from PowerMaster control panel or Monitoring Station saves the need to physically
l
access the shock detector for configuration
Remote view of: Low Battery, front and back Tamper, Supervision
l
An LED lights whenever alarm or tamper events are reported (the LED does not light while a supervision message is being transmitted).
l
2. INSTALLATION
2.1. Mounting
Refer to the Shock Detection Radius, in the Specifications section, according to the surface material used. Install the device in a location where a strong
shock impact is expected. The unit should be mounted on a flat surface and firmly fixed using both mounting screws.
For magnetic contact detection, it is highly recommended to attach the detector to the door or window on the fixed frame and the magnet to the movable
part (door or window). For optimal magnetic sensor activity and better security it is recommended to apply the magnet as close as possible to the
detector's marked side.
Note: Once the cover is removed, a tamper message is transmitted to the control panel. Subsequent removal of the battery prevents transmission of
"TAMPER RESTORE", leaving the detector in permanent alert. To avoid this, press the tamper switch while you remove the battery.
Caution! Risk of explosion if battery is replaced by an incorrect type. Dispose of used battery according to manufacturer's instructions.
Attention! The unit has a back tamper switch (optional) under the PCB. As long as the PCB is seated firmly within the base, the switch lever will be
pressed against a special break-away base segment that is loosely connected to the base ("Figure 2. Base with P.C. Board Removed" above). Be sure
to fasten the break-away segment to the wall. If the detector unit is forcibly removed from the wall, this segment will break away from the base,
causing the tamper switch to open.
D-304286 SD-304C PG2 Installation Instructions
Figure 2. Base with P.C. Board Removed
Installation Instructions
A. Transmission LED
B. Magnet
Figure 1. External View
A. Auxiliary input terminals
B. Back tamper switch
(behind P.C. board)
C. Battery clips
D. Break-away segment (for
back tamper
E. Digital display
F. Front tamper switch
G. Enroll button
H. LEDs indication
I. Reed switch
J. Up and down buttons
1