Visonic SPY 1 Installation Instructions

SPY 1, 2, 3, 4 SPY 1, 2, 3, 4 SPY 1, 2, 3, 4 SPY 1, 2, 3, 4
Miniature PIR Detectors
1. INTRODUCTION 1. INTRODUCTION 1. INTRODUCTION 1. INTRODUCTION
• Ultra-miniature
• Reliable
• Trouble free
• Four different models for different applications.
• Virtually unnoticeable when installed
• Fast, easy installation
• In-ceiling or in-wall installation
• Special anti-false alarm features:
− − − − 2-step built-in pulse counter
− − − − Light rejection filter to reject visible light variations
− − − − Dual-element low-noise pyroelectric detector
• RF immunity up to 1000 MHz
• N/C silent relay output
• Low 12.5 mA current drain @ 12 VDC
• 10-14 VDC supply voltage
The new SPY series features the smallest passive infrared (PlR)
detectors of their type presently marketed. Models are designed
for in-wall or in-ceiling installation, or behind the wall (or ceiling)
mounting. The only visible part of the SPY after installation is the
ultra miniaturized lens itself.
SPY 1 - Long Range
Note: These units are not designed for pet alley use.
2. SPECIFICATIONS 2. SPECIFICATIONS 2. SPECIFICATIONS 2. SPECIFICATIONS
OPTICAL - Detection Patterns
Long Range; narrow angle corridor pattern. Coverage
SPY 1
Area: max. 11 m/17° (35 ft/17°)
Medium Angle; 3 double beams in a single detection
SPY 2
layer. Coverage Area: max. 8 m/50° (25 ft/50°)
Wide Angle; 6 double beams in a single detection
SPY 3
layer. Coverage Area: max. 8 m/100° (25 ft/100°)
Curtain; solid curtain pattern. Coverage pattern: max.
SPY 4
2 m wide x 4 m high (6 x 12 ft)
ELECTRICAL
Voltage: 10 - 14 VDC
Current: 12.5 mA @ 12 VDC
DE1151 SPY 1, 2, 3, 4 Installation Instructions
SPY 2 - Medium Angle
Installation Instructions
False alarms caused by environmental disturbances are virtually
eliminated by a combination of light rejection filter and pyro-
electric low-noise detector. The medium angle, wide angle and
curtain SPYs have the additional protection of built-in two-step
pulse counting. With careful attention to installation site and
periodic walk-testing, Visonic Ltd. SPY PlR detectors will give
reliable, long-life, trouble-free service.
Models available:
SPY 1: Long Range. Provides narrow angle corridor pattern with
maximum coverage area of 11 m/17° (35 ft/17°).
SPY 2: Medium Angle. Provides 3 double beams in a single
detection layer with maximum coverage area of 8 m/50°
(25 ft/50°)
SPY 3: Wide Angle. Provides 6 double beams in a single
detection layer with maximum coverage area of 8 m/100°
(25 ft/100°).
SPY 4: Curtain. Provides a solid curtain with maximum coverage
pattern of 2 m width x 4 m height (6 x 12 ft).
SPY RTE-A: Special request-to-exit model, relay output.
SPY RTE-B: Request-to-exit model, open collector output.
SPY 3 - Wide Angle
Alarm Output
SPY 1, 2, 3, 4 and SPY RTE-A: Normally closed (fail-safe)
contacts. Rating: 0.1 A resistive / 30 VDC. 18-ohm resistor in
series with contacts.
SPY RTE-B: Open collector output, 50 mA maximum
Alarm Period
SPY 1, 2, 3, 4: 2-10 seconds
SPY RTE-A and B: 1-2 seconds
Detector: Dual-element, low-noise pyroelectric detector
Pulse Counter
SPY 2, 3 and 4: Factory set to 2 pulses alternate polarity
SPY-1 and SPY RTE-A and B: 1 pulse
SPY 4 - Ceiling Mounted Curtain
SPY 4 - Wall Mounted Curtain
1