Table of Contents
Advertisement
SSB-927R-E2C-JB User's Manual
Sliding the Chassis onto the Rack Rails
Warning: This requires at least two people to support the chassis during instal-
lation. Please follow safety recommendations printed on the rails.
Installing the Chassis into a Rack
1. Pull the middle rail out of the front of the outer rail and make sure that the ball
bearing shuttle is locked at the front of the middle rail.
2. Align the rear of the chassis rails with the middle rails and then push evenly on
both sides of the chassis until it clicks into the fully extended position.
3. Depress the locking tabs on both sides of the chassis and push the it fully into
the rack. The locking tabs should "click".
4. Optional screws may be used to hold the front of the chassis to the rack.
Note: The figure above is for illustrative purposes only. Always install servers to
the bottom of the rack first.
Caution: Do not pick up the server with the front handles. They are designed
to pull the system from a rack only.
Figure 2-6. Installing into a Rack
2-8
Advertisement
Table of Contents
