Supermicro SSG-927R-E2CJB User Manual page 52

SSG-927R-E2CJB User's Manual
Figure 5-5. Removing Dummy Drive from Carrier
Installing a Drive into the Carrier
1. Install a new drive into the carrier with the printed circuit board side facing down
so that the mounting holes in the drive align with those in the carrier.
2. Secure the hard drive into the carrier with the screws.
3. Use the open handle to replace the drive carrier into the chassis.
4. Gently close the drive carrier handle to secure the drive and carrier into the
chassis drive bay.
Figure 5-6. Installing the Hard Drive
5-6