All buffer data is deleted after printing.
The print area set by ESC W (Set print region in page mode) is reset to the
No paper cut is executed.
Sets the print position to the beginning of the next line after execution.
This command is enabled only in page mode.
CR
[Name]
Print and carriage return
ASCII CR
[Format]
Hex. 0D
Decimal 13
[Range]
N/A
When an automatic line feed is enabled, this command functions in the same
way as LF(print and line feed). When the automatic line feed is disabled, this
[Description]
command is ignored.
This command is ignored with serial interface models.
Sets the print position to the beginning of the next line after execution.
CAN
[Name]
Cancel print data in page mode
ASCII CAN
[Format]
Hex. 18
Decimal 24
[Range]
N/A
Deletes all print data in the currently set print region in page mode.
This command is enabled only in page mode.
[Description]
Portions included in the currently set print region are also deleted, even if
DLE EOT n
[Name]
Real-time status transmission.
ASCII
[Format]
Hex.
Decimal
1 ≤ n ≤ 4
[Range]
Transmits the selected printer status specified by n in real time, according to the
following parameters:
[Description]
n = 1 : Transmit printer status. n = 2 : Transmit off-line status.
n = 3 : Transmit error status. n = 4 : Transmit paper roll sensor status.
PA-8225 SERIES USER
default setting.
previously set print region data.
OLE EOT n
10
16
4
'
S MANUAL
04
n
n
Chapter 3 Software
Page: 3-14