Table of Contents
Advertisement
Tool Disassembly
WARNING: Always unload a powder actuated tool before disassembling,
replacing barrel, cleaning, or assembling.
A. REMOVING BARREL ASSEMBLY
1.
Using screwdriver, lift end of annular spring and rotate spring until key stop is
uncovered (see Figure 1).
Figure 1 - Rotating Annular Spring to Uncover Key Stop
2.
Push key stop towards rear of tool and remove (see Figure 2).
3.
Firmly grip and pull barrel assembly from the outer liner assembly.
4.
Unscrew muzzle cap.
5.
Pull plastic buffer out of muzzle cap (see Figure 3).
Figure 3 - Separating Barrel Assembly from Housing
6.
Pull piston assembly, using moderate force, from barrel (see Figure 4).
Piston
Assembly
Figure 4 - Removing Piston Assembly from Barrel
Figure 2 - Removing Key Stop
Plastic
Buffer
Muzzle Cap
Annular Spring
Key Stop
Key Stop
Barrel
Assembly
Piston
18
Outer Liner
Assembly
Barrel
106763
Advertisement
Table of Contents
