Table of Contents
Advertisement
Tool Assembly (Cont.)
G. ATTACHING REAR PAD ASSEMBLY
1.
Push the rear pad and power indicator assembly onto housing, aligning screws
with holes in housing.
2.
Holding pressure on rear pad and indicator assembly, tighten screws with 3mm
hex wrench. Note: Rear pad and power indicator assembly is spring loaded.
Pressure should be kept on the assembly at all times while tightening screws
to avoid loosing parts.
Figure 21 - Attaching Rear Pad and Power Indicator Assembly
H. ATTACHING HANDLE PAD ASSEMBLY
1.
Place handle pad assembly onto housing body and tighten screw with 3mm hex
wrench. Make sure rocker arm spring stays tight against the handle pad
assembly while tightening screw.
I. ASSEMBLING BARREL ASSEMBLY
1.
Using moderate force, insert piston assembly into barrel (see Figure 23).
Piston
Assembly
Figure 23 - Inserting Piston Assembly into Barrel
Figure 22 - Attaching Handle Pad Assembly
Housing
Rocker Arm
Spring
Handle Pad
Assembly
3mm Hex
Wrench
24
Screws
Rear Pad and Power
Indicator Assembly
Barrel
106763
Advertisement
Table of Contents
