Remington 500V Operating Instructions Manual page 19

B. REMOVING HANDLE PAD ASSEMBLY
1. Loosen screw on back of handle pad assembly with 3mm hex wrench. Do not
remove the screw from the assembly (see Figure 5).
2. Remove handle pad assembly.
C. REMOVING REAR PAD AND POWER INDICATOR ASSEMBLY
1. Keeping pressure against the back of the rear pad and power indicator assembly,
loosen screws using a 3mm hex wrench. Slowly release pressure. Note: Rear
pad and power indicator assembly is spring loaded. Pressure should be kept on
the assembly at all times while loosening screws to avoid loosing parts.
2. Pull rear pad and power indicator assembly out of housing (see Figure 6).
Figure 6 - Removing Rear Pad and Power Indicator Assembly
D. REMOVING ROCKER ARM ASSEMBLY
1. Remove the larger spring from the outside of the outer liner assembly and the
firing pin spring from inside the outer liner assembly (see Figure 7).
2. Remove rocker arm pin with hammer and punch.
3. Remove rocker arm assembly from housing (see Figure 7).
Housing
Rocker Arm Pin
Figure 7 - Removing Rocker Arm Assembly from Housing
106763
Figure 5 - Removing Handle Pad Assembly
Rear Pad and Power
Indicator Assembly
Housing
Rocker Arm Assembly
Rocker Arm Spring
19
Handle Pad Assembly
3mm Hex Wrench
Screws
Firing Pin Spring
Spring
Continued