Table of Contents
Advertisement
CAST IRON
GLASS
G 018
2.
NEVER attempt to drive power fasteners into very hard or brittle materials
including, but not limited to cast iron, glass, tile, stone, brick, or hardened steel.
Materials of this type tend to shatter and create hazards from flying particles.
G 018
3.
NEVER make fastenings in spalled or cracked areas.
G 018
4.
NEVER drive power fasteners into thin or easily penetrated materials unless it
is backed by concrete or steel. When in doubt, such as when base material is
concealed, conduct a Center Punch Test (See page 6). Check continually to
avoid fastening into unsuitable material, especially in older buildings.
5.
DO NOT fasten through or within 1/2" of predrilled or pre-punched holes.
106763
Safety Precautions
BRICK
TILE
G 018
482-33
G 018
7
Continued
Advertisement
Table of Contents
