Advertisement
3
Installation
Note:
Please read the instructions carefully before installing the R2c.
R2c
Remove the back piece of the R2c from the main piece. Secure the back piece of R2c onto
1
wall using the 3 screws provided but make sure that you have some space for the wires to go
through the hole.
Pass the wire from R2c through the small gap in the back piece.
2
3
Secure the R2c on the back piece and tighten the screw at the bottom.
Verification •
Fingerprints
4
Make sure the R2c is in its standby mode, where the green LED light is blinking and the
1
user's fingerprint has been enrolled into a master terminal before you proceed to verify.
2
Place a finger on the fingerprint scanner to scan a fingerprint. You will hear a beep, to
indicate the fingerprint has been captured and sent to master terminal to verify.
Verification result:
3
a. Successful Verification:
Green LED blinks accompanied by a beeping sound.
b. Failed Verification:
Red LED blinks accompanied by 2 beeping sounds.
2
1
Back piece
1
1
3
5
Verification •
Cards
1
Make sure the R2c is in standby mode, where the green LED light is blinking and a card ID
has been enrolled into a master terminal before you proceed to verify.
2
Wave card on the inducation area to capture the card information. You will hear a beep,
indicating the card information has been captured and sent to the master terminal to
verify.
Verification result:
3
a. Successful Verification:
Green LED blinks accompanied by a beeping sound.
b. Failed Verification:
Red LED blinks accompanied by 2 beeping sounds.
NOTE: Specifications are subject to change. Check http://product. ngertec.com for latest product information.
SPECIFICATIONS
MODEL
R2c
SURFACE FINISHING
Acrylonitrile butadiene styrene (ABS)
TYPE OF SCANNER
Optical ngerprint scanner
MICROPROCESSOR
Managed by master terminal
MEMORY
ALGORITHM
Support BioBridge VX 10.0
64 x 42 x 135
PRODUCT DIMENSION (L x W x H), mm
STORAGE
• Fingerprint templates
Storage in master terminal
• Transaction
ENROLLMENT & VERIFICATION
Fingerprint (1:N) & card
• Methods
Managed by master terminal
• Recommended fingerprint per user ID
Any angle
• Fingerprint placement
• Verification time (sec)
Managed by master terminal
• FAR (%)
• FRR (%)
CARD TECHNOLOGY
• RFID: 64-bit, 125kHz
Yes
• MIFARE: MF1S50/S70, 13.56MHz
Made to order
COMMUNICATIONS
• Method
RS485
OPERATING ENVIRONMENT
• Temperature (°C)
0 ~ 45
• Humidity (%)
20 ~ 80
• Power input
Managed by master terminal
ACCESS CONTROL
• EM lock driving output
Managed by master terminal
• Alarm output
• Antipassback
R2c
R2c
Slave Fingerprint Access
Control Terminal
Fingerprint
Card
Advertisement
