Rs485 Port Connection (Only Hybrid Models) - Bosch DIVAR 2000 Operation Manuals

24 en | Hardware setup
5.2

RS485 port connection (only hybrid models)

Use the RS485 connector to connect Bosch, Pelco-P or Pelco-D controllable cameras to the
unit for pan, tilt, and zoom control. RS485 is a single-direction protocol; the PTZ device can't
return any data to the unit.
Since RS485 is disabled by default for each camera, you must enable the PTZ settings as
follows:
1. Connect a suitable cable to the RS485 connection on the DVR rear panel.
2. Connect the other end of the cable to the appropriate pins in the camera connector.
3. Follow the instructions in the Operation section of this manual to configure the camera
for PTZ control.
The Bosch protocol is supported with the following baud settings:
– 9600 baud
– 8 data bits
– 1 stop bit
– no parity
– no flow control
2016.09 | v1.0 | AM18-Q0717
_
+
+12V G
KEYBOARD
Operation Manual
Available from A1 Security Cameras
www.a1securitycameras.com email: sales@a1securitycameras.com
G +12V
_
+
_
+
+12V G
Keyboard RJ11 cable (or equivalent)
DIVAR 5000
DIVAR 2000 / DIVAR 3000 / DIVAR
5000
_
+
G +12V
+ _ + _
G
G G G
power to keyboard
keyboard control
RS-485 KEYBOARD
Bosch Security Systems