Table of Contents
Advertisement
Digital Video Recorder 440/480 Series
4.6
USB connectors
A USB 2.0 connector is located at the rear panel of the unit to which a mouse, for example,
can be connected. For convenience, the USB 2.0 port is located on the front of the unit to
connect a mouse or USB memory device. (Recording to a USB-drive is not supported.)
Figure 4.7 USB connector (on front and on rear)
4.7
RS485 port
Connect Bosch or third-party controllable cameras to the unit for pan, tilt, and zoom control.
The Bosch protocol is supported with the following baud settings:
Figure 4.8 RS-485 connector
Signal name
TX -
TX +
GND
Table 4.3 RS485 pin definition
The recommended cable cross section is AWG 28-16 (0.08-1.5 mm2).
Bosch Security Systems
–
9600 baud
–
8 data bits
–
1 stop bit
–
no parity
–
no flow control
Pin number
1
2
3
Installation and Operation manual
Description
Data transmission
Data transmission
Shield
Hardware setup | en
25
AM18-Q0605 | v2.0 | 2012.04
Advertisement
Table of Contents
