General Troubleshooting - Baumatic BFD64SS Instruction Manual

General troubleshooting

PROBLEM
Dishwasher
doesn't
run
Drain pump
doesn't stop
Noise
Suds in the
tub
Stained tub
interior
Dishes are not
fully dried
Downloaded from www.Manualslib.com
POSSIBLE
CAUSES
Fuse blown or the
circuit breaker has
tripped
Power supply is not
switched on
Water pressure is low
Overflow
Some audible sounds
are normal
Utensils are not
secure in the baskets
or something small
has dropped into the
basket
Motor hums
Improper detergent
use
Spilled rinse aid
Detergent with
colourant was used
Rinse aid dispenser is
empty
manuals search engine
WHAT TO DO
Replace the fuse or reset the circuit
breaker. Remove any other
appliances that are sharing the same
circuit with the dishwasher.
Make sure that the dishwasher is
turned on and that the door is closed
securely.
Make sure that the power cord is
fully plugged into the wall socket.
Check that the water supply is
connected properly and that the
water is turned on.
The system is designed to detect an
overflow. If it does, then it will run
the drain pump continuously when
there is power to the appliance.
You will get a level of operating
noise during a wash cycle, in
particular when food is being
removed from items and when the
detergent dispenser places the tablet
into the tub.
Ensure that everything is loaded as
per Baumatic's loading instructions.
If the dishwasher is not going to be
used for a period of time, then you
should make sure that the appliance
is set on a wash program once a
week. Otherwise the seal around
motor may dry out and cause noise.
Ensure that you are not using 3 in 1
detergent tablets, in conjunction
with rinse aid and salt.
Always wipe up any excess rinse aid
or rinse aid spillages immediately.
Use a detergent without colourant.
Make sure that the rinse aid
dispenser is filled with rinse aid.
29