Table of Contents
Advertisement
28) Locate the ground lug at the receptical box,
left of the unit.
29) Connect one end of the supplied green
ground wire to the lug with the nut and
washer from the kit.
Ground
wire from
kit
30) Install the 1/2" bushing to the heat
shield.
31) Run the other end of the ground wire and
DC spark generator wires through the
bushing on the heat shield.
Heat Shield
®
Regency
P48-2 Zero Clearance Direct Vent Gas Fireplace
32) Plug the DC spark generator wires to the
DC Sparker.
33) Connect the ground wire to the DC Sparker
mounting bracket.
34) Install the supplied battery into the DC
Sparker Box by opening the battery
compartment.
NOTE: The battery in the DC Sparker Box
will need to be replaced annually.
Battery
Compartment
INSTALLATION
35) Mount the heat shield to the DC Sparker.
Secure into place with the velcro, which is
provided in the kit.
36) Find a location which is not too hot and
is easy to reach for changing the battery.
Note: It should be kept away from the
chain.
Chain
37) Tie up the loose wire with the wire clip.
29
Advertisement
Table of Contents
