Table of Contents
Advertisement
14. Please connect the Cable No. 18 (USB Type A to USB Type A Cable) from the DEV2 Mini-USB
interface on the rear panel of the RMC-400 to the USB interface on the rear panel of another HDR-
10.
4. First locate the DC jack on the RMK-6 and on the inner side of the DC jack, you should find four
DC plug cables attached. Connect Cable No. 1 / 2 / 3 / 4 (DC Plug Cable) to the SE-500HD, TLM-
102, NVS-25, and HDR-1 DC jacks respectively and secure by tightening the outer fastening ring.
15. First locate the DC jack on the RMK-6 and on the inner side of the DC jack, you should find four
DC plug cables attached. Connect Cable No. 1 / 2 / 3 / 4 /5(DC Plug Cable) to the SE-500HD, TLM-
102, the DC IN power interfaces located at the top left side and bottom left side on the rear panel
of the aluminum power box module, and the power interface of the built-in HDMI splitter
respectively and secure by tightening the outer fastening ring.
18
2
3
4
15
5
1
Advertisement
Table of Contents
