Installation - EverFocus EP-DMD4 Installation And Operation Instructions Manual

1.0 Installation

Thank you for your decision to use the Digital Video Sensor EP-DMD-4 in
your application.
We ask you to read thoroughly through the brief instructions, so that you can use the
EP-DMD-4 functions in an optimum way for your system.
Before installing the equipment, please read the safety instructions on page 35.
Check the included accessories for completeness:
1 x plug-in power supply 9V DC, 2.0A
2 x mounting brackets with screws for mounting in a 19" rack
1x CAT5- Crossover Patch cable 2m
1 x 25 pin D-SUB soldering plug with cover and mounting hardware
1 x male / 1x female 9pin D-SUB soldering plug with cover
1 x CD-ROM with installation software
4 x self-adhesive equipment feet
Please contact your dealer directly, if any of the accessories should be missing!
1.1 PC Setup Dialog
The PC setup program for the EP-DMD-4 video sensor uses the Windows systems
2000/ XP. The screen resolution should be set to at least 800 × 600 and the
number of colors should be set to True Color.
To install the program from the included CD-ROM, run Setup.exe in the "DMD4" fold-
er. Follow the program instructions and install the DMD-4 setup in the desired folder.
After the installation has been completed, start the program DMD4 via the standard
Windows menu Start Program Files DMD4. The setup program for the DMD-4
will be executed.
The program can be uninstalled via the Windows control panel menu "Software".
1.2 EP-DMD-4
Please connect the video signal of the video cameras to the BNC inputs 1 through 4.
By using the loop-through-Video outputs please and connect the outputs to the moni-
tors, camera switches, etc.
After connecting the power supply the blue symbol "Power LED" lights up.
3-5 seconds after the sensor is initialized (the yellow LED is flashing) and ready for
operation.
To configure the EP-DMD-4, connect the Ethernet interface of the sensor to the LAN port
of a PC or a laptop. Use the included crossover-cable for that purpose.
Important:
If you connect the DMD to a network hub/switch please use a 1:1-patch cable!
After starting the PC setup program, you can setup the DMD-4.
- 4 -
Dear Customer!
1.0 Installation