Table of Contents
Advertisement
6.1. Menu
- 15 -
Dome-Tracking:
Using the mode Dome tracking the sensor controls the presets of a P&T head regard-
ing to the coordinates of an object, which has been detected. According to different
camera-types and –protocols the sensor has to be programmed with a special ‚Dome-
Firmware„ (see Sensor options). An information about the activated protocol appears
by using the ‚Dome-Typ‟-button (The default protocol is ‚Panasonic„).
The individual setting of presets, dome address and home position can be adjusted for
each channel in the following dialog box:
First of all the Dome tracking mode has to be activated (‚Tracking On„) and the dome
address has to be entered. Optionally you can define a home position: After expiration
of ‚time„ since the last preset command the sensor will call up this preset number
automatically. Note: Activating the Dome tracking mode automatically activate the
RS485 interface (s.p. 28).
All preset numbers can be defined for each cell within a 16x16 grid:
Using the numeric pad buttons of ‚preset„ the actual preset number in the position field
is entered. Then the mouse cursor is positioned on a grid cell and by clicking the left
mouse button the cell is defined by this number. Deleting cells is performed as follows:
Define the actual position as ‚Delete„ (‚Delete„ button) and click on the desired cell.
When the mouse cursor is positioned on a cell, that has been already defined, the pre-
set number of ‚position„- field will be overwritten by the cell-preset by clicking the right
button.
To control defined presets in according to the picture areas of the reference camera
you can activate ‚Dome Test ON' using the connected sensor/dome:
Clicking on a defined cell or using the numeric pad on the left and the ‚Select„ button
the sensor will send the command for the desired preset number. If required you can
manually adjust the settings of the preset (P/T, zoom, focus, iris).
Please use the button ‚Save„ to store the new preset settings in the dome.
The window of ‚Status„ shows the last commands.
Advertisement
Table of Contents
