Table of Contents
Advertisement
6.1. Menu
IMPORTANT: The following conditions have to be performed for dome tracking:
The
centre
of
mode/perspective„;The channel is activated; The object size is between minimum
and maximum number of cells.
Copy Setup Data:
or Alarm strings the source/target-configuration of timezone is important:
According to the upper timezone definition all camera data /alarm strings of camera 2,
timezone 1 will be copied to timezone 3 of camera 3 and 4.
Therefore the user does not have to program the whole setup anew if the parameters
of the sensor areas only differ marginally.
Change Password:
The setup data is protected from unauthorized access by a password. A data trans-
mission can only be executed successfully if the password of sensor and PC program
is the same. It is recommended to alter the password immediately after the first start of
the setup program.
NOTE:
The password can only be changed when the sensor is connected to the PC interface
and has a maximum length of 10 characters and is case-sensitive!
The password can be changed in the following dialog box:
- 16 -
gravity
of
the
object
Old Password: Enter the current password of the DMD.
The pre-configured password is "video".
New Password: Enter the new password.
Confirm Password: Repeat and confirm the new
password.
The new password is accepted by clicking "Change pass-
word".
Attention:
When the password has been lost, please contact your
dealer.
is
within
an
area
This option allows the copying of
sensor settings within the channels or
timezones:
In the left example all data of timezone
1 will be copied to timezone 3+4 over
all 4 channels, regardless of the
„Camera‟- configuration.
However, by copying Camera settings
‚object
with
Advertisement
Table of Contents
