Table of Contents
Advertisement
6.1. Menu
Change IP- settings:
Allows reading out and changing the actual IP-configuration of the sensor.
Notes: Changing of the IP-address will always result a disconnection of the estab-
lished network connection. If necessary the PC / laptop have to be switched to the new
IP-address. It is recommended documenting the actual IP-configuration.
Load Default:
Restores the default values (restart) of the PC user interface.
ATTENTION: A reset overwrites all current setup settings of the user interface
with default values!
COM:
Use COM:
Defines the kind of configuration interface Ethernet (default) or RS232-comport (set-
tings see above). By clicking to point ‚Use COM„ you switch between of using Comport
(a ‚„ appears in front of ‚Use COM„) and the Ethernet ( the ‚„ disappears ).
Change password:
Opens a submenu for changing the actual password setting. You will find further de-
scriptions on page 16.
Change language:
Opens a window for changing the actual language setting of the PC-program.
The setting will be valid after a restart of the PC too.
- 18 -
Allows setting up the configuration-RS232 interface
of the PC (COM1...COM50), to which the sensor is
connected:
The DMD-4 interface is factory-configured as follows:
.. 8 data bits
.. no parity
.. RTS/CTS
.. Baud rate 115.2 kB.
Advertisement
Table of Contents
