Assembly - Reebok RBTL59110 User Manual

A
SSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (82) until the treadmill is in the position shown.
2. Remove the Lock Knob (110) from the Lock Pin (114).
Make sure that the Lock Pin Collar (112) and the Spring
(111) are on the Lock Pin as shown. Insert the Lock Pin
into the Latch Bracket (77).
Tighten the Lock Knob (110) onto the Lock Pin (114).
3. Refer to drawing 3a. Press a Handrail Insert (102) into
the lower end of a Handrail (85). Hold an Extension Leg
(103) against the lower end of the Handrail. Insert a
Handrail Bolt (78) with a Handrail Washer (36) into the
Extension Leg and thread the Handrail Bolt two or three
turns into the Handrail. Notice the angle of the Handrail
and insert the Handrail Bolt and Handrail Washer at the
same angle (see drawing 3b).
Attach a Handrail Insert (102) and an Extension Leg
(103) to the other Handrail (85) in the same way.
and rubber mallet
1
2
110
3a
6
.
82
77
111
112
3b
85
85
102
103
103
36
36
78
78
114