Table of Contents
Advertisement
ASSEMBLY
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• The underside of the walking belt is coated with
high-performance lubricant. After shipping, there
may be some lubricant on top of the walking belt
or on the shipping carton. This is normal. If there
is lubricant on top of the walking belt, wipe it off
with a soft cloth and a mild, non-abrasive cleaner.
• To identify small parts, see page 6.
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip
the treadmill onto its left side. Partially fold the
Frame (53) so that the treadmill is more stable;
do not fully fold the Frame yet.
Cut the shipping tie securing the Upright Wire
(88) to the Base (91). Locate a plastic tie in the
indicated hole in the Base, and use the tie to pull
the Upright Wire out of the hole.
Attach two Base Feet (89) to the Base (91) in the
locations shown with two #8 x 1" Tek Screws (6)
and two Base Foot Spacers (92).
Then, attach the other two Base Feet (89) with
two #8 x 1" Tek Screws (6).
• Assembly requires the following tools:
the included hex key
one adjustable wrench
one Phillips screwdriver
one pair of scissors
To avoid damaging parts, do not use power tools.
1
92
89
53
92
7
Hole
88
6
89
6
89
6
91
89
6
Advertisement
Table of Contents
